Slower progress the past month... It's been a mad rush to get our big boat launched and so I haven't had nearly as much time to work on the dingy.

Got the outer hull all faired. I'm not sure how fair I ended up getting it, but hopefully good enough. It was a lot of sanding...

Sanded up a bunch of the drips from over the gunwales. Wish I would have remembered to go along and clean those up when I glassed the gunwales as that would have been easier than sanding them down. However, a sanding block does make pretty short work of it.

Installed the skeg and then final epoxy coated the hull. Tipped with a heat gun to try and get a nice flat finish.

Started work on finishing up coating the holes and filled the skeg holes in the bottom of the boat.