A few little jobs getting the alighnment clips fitted, and then the holes oversized and filled with epoxy.

Lots of sanding and de-dusting prep for coating the inner hull. Did a big garage cleanup to try and minimize dust, and then a lot of sanding, vacuuming, wiping down, and then tack clothing to get things nice and clean.

Manual suggested splitting the aft hull in two and coating one side each day, but we did it all in one go with Theone helping out by pumping and mixing epoxy so I could just continually roll and tip. That worked really well and it wasn't too much trouble to keep a wet edge going for the entire hull length.

This was a big step that is nice to have done now. Next is on to painting the outside of the hull.